WSH410
Winson reserves the right to make changes to improve reliability or manufacturability.
Hall Effect Sensor IC with Complementary Output
Drivers and Frequency Generator
Features:
Operate from 2.8V to 20V supply voltage.
On-chip Hall sensor.
Internal bandgap regulator allows temperature compensated operations and a
wide operating voltage range.
High output sinking capability up to 400mA for driving large load.
Lower current change rate reduces the peak output voltages during switching.
Available in rugged low profile SIP-4L/SIP-5L packages.
Built-in protection diode for reverse power supply fault.
General Description:
WSH410 is designed to integrate Hall sensor with complementary output drivers
and frequency generator together on the same chip, it is suitable for speed
measurement, revolution counting, positioning, and DC brushless motors. It includes
a temperature compensated voltage regulator, a differential amplifier, a Hysteresis
controller, two open-collector output drivers capable of sinking 400mA current load.
An on-chip protection diode is implemented to prevent reverse power fault.
The temperature-dependent bias increases the supply voltage of the hall plates
and adjusts the switching points to the decreasing induction of magnets at higher
temperatures. Subsequently, the open collector output switches to the appropriate state.
WSH410 are rated for operation over temperature range from 20 C to125C and
voltage ranges from 2.8V to 20V.
Name
P/I/O
Pin#
Description
Vcc
P
Positive Power Supply
OUT1
O
Output Pin #1
OUT2
O
Output Pin #2
Vss
P
Ground
Winson Semiconductor Corp. 2005/8/12
1
WSH410
Winson reserves the right to make changes to improve reliability or manufacturability.
Name
P/I/O
Pin#
Description
Vcc
P
Positive Power Supply
OUT1
O
Output Pin #1
OUT2
O
Output Pin #2
FG
O
Frequency Generator
Vss
P
Ground
Supply Voltage
Vcc --------------------------
20V
Output / FG breakdown Voltage Vout/Vfg --------------------- 25V
Magnetic flux density
B
--------------------------
Unlimited
Reverse Protection Voltage
Vr --------------------------
20V
Output Current continuous
Ic
--------------------------
300mA
Hold current Ih ------------------------ 400mA
Peak current Ip ------------------------- 800mA
FG ON Current (continuous) If -------------------------- 20mA
Operating Temperature Range
Ta --------------------------
(-20C to +125C)
Storage Temperature Range
Ts --------------------------
(-65C to +150C)
Package Power Dissipation
Pd -------------------------- 500mw for SIP-4L
SIP-5L
(T=+25C, Vcc=2.8V to 20V)
Characteristic
Symbol Test Conditions
Min
Typ
Max Units
Supply Voltage
Vcc
V
Output Saturation
Voltage
Vout(sat) Vcc=20V, Ic=200mA
B > Bop
V
FG Saturation
Voltage
Vfg(sat) Vcc=20V, If=10mA
B > Bop
V
Output Leakage
Current
Ileakage Vcc=20V, B < Brp
<
UA
Supply Current
Isupply Vcc=20V, Output &
FG Open
MA
Output / FG Rising
Time
Tr
Vcc=12V, RL=820
CL=20Pf
3.0
Us
Output / FG Falling
Time
Tf
Vcc=12V, RL=820
CL=20Pf
Us
Output / FG Time
Differential
t
Vcc=12V, RL=820
CL=20Pf
Us
Winson Semiconductor Corp. 2005/8/12
2
PDF 
ZIP
