2-37
Dialight Corporation 1501 Route 34 South Farmingdale, NJ 07727 TEL: (732) 919-3119 FAX: (732) 751-5778 www.dialight.com
2
3mm Round
Optopipe
TM
Optical Light Pipe, 4 Array
515-1020
1.52
[.060]
2.34
[.092]
8.69
[.342]
15.09
[.592]
4.01
[.158]
1.35
[.053]
1.45
[.057]
1.70
[.067]
13.06
[.514]
3.56
[.140]
6.35
[.250]
3.18
[.125]
3.61
[.142]
4.19
[.165]
2.39
[.094]
2.00
[.079] TYP;
(3) PLACES
6.35
[.250]
22.66
[.892]
1.93
[.076
.002]
RECOMMENDED PIN HOLES AND SOLDER PAD
LAYOUT FOR SUGGESTED MicroLED LEDs
COMPONENT SIDE OF PRINTED CIRCUIT BOARD
3.00
[.118]
NOTE:
C.L. of
LED
3.56
[.140]
DIRECTION
OF LIGHT
Dimensions in mm [inches]
NOTE: designed for
post-reflow
PC board insertion.
Recommended
MicroLED SMT LEDs
for use with 515-1020
PART NO.
COLOR
PAGE #
597-3111-4xx
AlGaAs Red
1-28
597-3201-4xx
Orange
1-28
597-3311-4xx
Green
1-28
597-3401-4xx
Yellow
1-28
Features
High transmissivity polycarbonate material
UL94V-0 compliance
ESD protection (circuit isolation from front panel)
Wide viewing angle
Arrays reduce insertion costs
Secures to PCB by press-fit
For Snap Pin Retention Version, see Dialight's 515-1048
four Array Light Pipe
LED Data
For absolute maximum ratings and other
electrical and optical data on the recommended
LEDs, refer to LED data sheets.
Dialight
Optopipe
Light Pipe Description
This light pipe's circular light emitting surfaces appear bright and have good optical isolation. It is reliably held in place
by 3 press-fit pins located between the light pipe elements. This OptopipeTM functions as a through-the-case indicator with
a textured finish on the 4 light emitting surface that increases its viewing angle. The recommended light sources are
Dialight's 597 Series PLCC-2 or PLCC-4 Type SMT LEDs. The LEDs are mounted in a straight line on a 0.250" pitch. The
light pipe material is water clear transmissive polycarbonate rated UL94-V0, and has a 35% oxygen index.
Dialight can provide custom OptopipeTM solutions for your applications.
Operating/Storage Temperature
30C to +100C
PDF 
ZIP