APEX MICROTECHNOLOGY CORPORATION TELEPHONE (520) 690-8600 FAX (520) 888-3329 ORDERS (520) 690-8601 EMAIL prodlit@apexmicrotech.com
1
INTRODUCTION
This easy-to-use kit provides a platform for the evalua-
tion of the PB50 and PB58 high voltage power boosters.
The PB50 and PB58 are designed most commonly in
combination with a small signal, general purpose op
amp. However, they can also be used without a driver
amplifier. This kit can be used to analyze a multitude of
standard or proprietary circuit configurations.
PARTS LIST
Part #
Description
Quantity
HS13
Heatsink
1
EVAL01
PC Board
1
MS03
Mating Socket
1
HWRE02
Hardware Kit
1
HWRE05
8-Pin Wire Wrap Socket
1
TW0 3
Thermal Washer
1 Box/10
HWRE02 contains the following:
4 #8 x .375" Panhead Screws
4 #8 x .375" Hex Spacers
4 #8 x 2.00" Hex Stand Offs
2 #6 x 1.25" Panhead Screws
2 #6 x 5/16" Hex Nuts
CAUTION
1. Use thermal grease or Apex Thermal Washer TW03 between power booster and heatsink.
2. Use 18 gauge teflon sleeve on at least two opposite pins
3. Mounting torque greater than 7 inlbs on power booster mounting bolts will void warranty!
ASSEMBLY
APEX MICROTECHNOLOGY CORPORATION 5980 NORTH SHANNON ROAD TUCSON, ARIZONA 85741 USA APPLICATIONS HOTLINE: 1 (800) 546-2739
2
EQUIVALENT SCHEMATIC
EK50
EVALUATION KIT FOR
PB50/PB58 POWER BOOSTERS
This data sheet has been carefully checked and is believed to be reliable, however, no responsibility is assumed for possible inaccuracies or omissions. All specifications are subject to change without notice.
EK50U REV D OCTOBER 2004 2004 Apex Microtechnology Corp.
PDF 
ZIP